The Longlife Air drier works on the basis of the silica gel material removing the moisture out of the air as it passes through the plastic container. In wet atmospheric conditions the gel will absorb moisture and will change colour to red if it has absorb much moisture.
When this happens the silica gel must either be heated up and dried or replaced. The heating up can be done in the oven, microwave oven or direct sunlight. First remove the drier from the body of the generator by pulling the 2 plastic connections out from the side panel connections. To remove the silica gel for drying unscrew the end cap, perforated plate and foam rubber insert. Place the silica gel in to a glass or ceramic container and gently heat up until the colour changes back indicating removal of moisture.
DO NOT OVERHEAT OR COOK!!
Warranty: 2 years
Output R.H.Value: <20% RH 2.0L/min gas flow for 5 hours
Drying theory: Silica gel beads
Length: 250 MM
Air inlet/out diameter: 8.3MM(Use 8mm tube)
Applied 1-30grams ozone generator
The air dryer is filled with Silica gel beads which are highly absorbent when removing moisture from the ambient air.
1. Increase the efficiency of your ozone generator.
2. Stop particles from entering your ozone generator by its filters
3. Change colour from blue to pink when full with moisture.
4. Can be easily recharged by putting the whole unit into an oven or microwave.